Product ID:S.G. SILICONE ALKYD ENAMEL
MSDS Date:02/10/1989
FSC:8010
NIIN:01-263-9800
MSDS Number: BRFVK

Emergency Phone: 206-941-1619

Info Phone: 206-244-8844

Cage: 2F266

Telephone: 206-244-8844

Cage: 2F266

MINERAL SPIRITS (VAPOR PRESSURE 2.0 MM HG @ 68 F) (SARA

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 30 - 35%

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9293

Health Hazards Acute and Chronic:EYES:CAN CAUSE SEVERE
IRRIT,REDNESS,TEARING,BLURRED VISION.SKIN:PROLG/REPEATED CONTACT
CAN CAUSE MOD IRRIT,DEFATTING,DERMATITIS.INHALE:EXCESSIVE INHALE OF
VAPORS CAN CAUSE NASAL/RESP IRRIT,DIZZINESS,W
EAKNESS,FATIGUE,NAUSEA,HEADACHE,POSS UNCONSC,ASPHYXIATION.INGEST:GI
IRRIT,NAUSEA,VOMIT,DIARRHEA,ASPIRATION OF MATERIAL*
Effects of Overexposure:* INTO THE LUNGS CAN CAUSE CHEMICAL PNEUMONITIS
WHICH CAN BE FATAL.

First Aid:SKIN: WASH W/SOAP & WATER. REMOVE CONTAM CLOTHING. EYES:
FLUSH W/LRG AMTS WATER, LIFT EYELIDS. GET MED AID. INGEST: DONT
INDUCE VOMIT. KEEP WARM, QUIET, GET MED AID. ASPIRATION OF MAT'L
INTO LUNGS (VO MITING) CAN CAUSE CHEM PNEUMONITIS (CANBE FATAL).
INHAL: REMOVE TO FRESH AIR. IF BREATHING DIFFICULT, GIVE OXYGEN. IF
BREATHING STOPPED, GIVE ARTIF RESP. KEEP QUIET & GET MED AID.

Flash Point Method:TCC
Flash Point:100F,38C
Lower Limits:1.0
Extinguishing Media:FOAM, DRY CHEMICAL, CO2
Fire Fighting Procedures:SELF-CONTAINED BREATHING APPARATUS WITH A FULL
FACEPIECE OPERATED IN PRESSURE DEMAND OR OTHER POSITIVE PRESSURE
MODE.
Unusual Fire/Explosion Hazard:NEVER USE NEAR OR AROUND WELDERS OR
CUTTING TORCHES. DRUM (EVEN EMPTY) BECAUSE PRODUCT (EVEN JUST
RESIDUE) CAN IGNITE EXPLOSIVELY.

Spill Release Procedures:SMALL: ABSORB LIQUID. TRANSFER TO HOOD. LRG:
ELIMINATE IGNIT SOURCES. EXCLUDE PERSONS NOT WEARING PROTECT EQUIP.
STOP SPILL AT SOURCE. PUMP LIQ TO SALVAGE TANK. PREVENT RUNOFF.
NOTIFY PROPER AUTHORITI ES AS REQUIRED.

Handling and Storage Precautions:CONTAINERS OF MAT'L MAY BE HAZARDOUS
WHEN EMPTIED, SINCE CNTNRS RETAIN RESIDUES, OBSERVE ALL HAZARD
PRECAUTIONS GIVEN IN MSDS.

Respiratory Protection:IF TLV EXCEEDED, NIOSH/MSHA AIR SUPPLIED
RESPIRATOR ADVISED IN ABSENCE OF ENVIRONMENTAL CONTROL. OSHA REGS
PERMIT OTHER NIOSH/MSHA RESPIRATORS UNDER SPECIFD CONDS. SEE SFTY
EQUIP SUPPLR. IMPLEMENT ENG INEERING/ADMIN CONTROLS TO REDUCE
EXPOSR
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL/LOCAL EXHAUST) VENT
TO MAINTAIN EXPOSURE BELOW TLV.
Protective Gloves:WEAR RESISTANT GLOVES (NITRILE)
Eye Protection:CHEM SPLASH GOGGLES,OTHER SFTY GLASSES
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
CONTACT WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:KEEP AREA FREE FROM SPILLS. WASH HANDS BEFORE
HANDLING FOOD & DRINK. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE.
Supplemental Safety and Health
NK

HCC:F4
Boiling Pt:B.P. Text:300F,149C
Vapor Density:> AIR
Spec Gravity:10.87 LBS/GAL
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:THIXOTROPIC LIQUID WITH A MILD SWEET AROMATIC ODOR
Percent Volatiles by Volume:50

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:KEEP AWAY FROM OPEN FLAMES, SPARKS, AND
HEAT. DO NOT WELD NEAR OR AROUND PRODUCT.
Conditions to Avoid Polymerization:KEEP AWAY FROM OPEN FLAMES, SPARKS,
AND HEAT. DO NOT WELD NEAR OR AROUND PRODUCT.

Waste Disposal Methods:DESTROY BY LIQUID INCINERATION. CONTAMINATED
ABSORBENT MAY BE DEPOSITED IN LANDFILL IN ACCORD W/LOCAL, STATE AND
FED REGS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.